The steps and projects of floor quality inspection, and the audit of the floor production factory
- Check if the color of the floor is consistent
We need to check if the color of the floor is consistent during acceptance. Generally speaking, wooden flooring allows for a certain degree of color difference, but if the color difference is too large and directly affects the aesthetics of the floor, it is necessary to request replacement; If the ground color is too consistent with almost no color difference, then it depends on whether the pattern on the surface of the floor is the same. Generally speaking, the pattern on the surface of solid wood flooring and reinforced composite wood flooring should be different for each piece, while the pattern on each piece of reinforced composite flooring is the same or similar.
- Check the surface quality of the floor
In addition to checking whether its surface is beautiful, we also need to observe whether there are insect infestations, gaps, scratches, etc. on its surface. If the ground keel is not treated with corresponding insect prevention measures, it will be easy to breed moths and gnaw on the floor from the inside out. Therefore, it is necessary for us to check this to avoid affecting the service life and durability of the floor.
- Check if the door latch strip is stable
For households that have installed wooden flooring, we also install door latch strips together when laying the flooring. It is mostly located directly below the door, and it is best to leave no edges inside or outside after closing the door. In addition, the gap between the buckle and the bottom of the door should be between 3-7 millimeters to ensure that the door can open and close freely.
- Check if the floor is deformed or warped
After the floor construction is completed, we need to check if there is any deformation or warping. At this point, we need to use specialized tools for acceptance. The acceptance method is to use a 2-meter long ruler, leaning against the floor, and the flatness should not exceed 3 millimeters. It is best for us to measure several more places, and if its pass rate is above 80%, it can be considered qualified. Alternatively, we can touch the corner where the floor meets the floor with our hands to see if the finished floor is flat. In addition, we can also walk back and forth on the floor to listen for any noise. If we find any areas with noise, we need to repeat the walk to determine the specific location of the noise and mark it for easy removal and re laying.
What are the standards for acceptance of wooden flooring
- The time node for floor acceptance is generally within three days after the floor is laid.
- The floor inspection needs to ensure that the surface of the floor is flat and clean, and the gaps between the wooden floors should be small and even. The inspection can be carried out by stepping on the floor and listening for any abnormal sounds.
- The direction of the floor construction length is specified before construction, and the spacing requirements meet the standard specifications. To ensure the effectiveness of use, it is necessary to maintain the use of buckle strips for the expansion joints of the floor for certain transitions.
Standard for acceptance of wooden flooring
- The floor acceptance can use a ruler as an auxiliary tool to detect whether the overall laying of the floor is uniform and whether there are any deformation issues.
- The first thing to pay attention to during the acceptance of the floor is to ensure that the brand, specifications, color, etc. of the floor meet the standards of the construction specifications. Generally, these are stipulated in the contract or have been verbally agreed upon.
- To conduct floor inspection, one can walk on the floor and try to use force as much as possible. If any abnormal sound is found, it is necessary to walk back and forth several times and carefully confirm. Any areas that fail the floor inspection require rectification.
- The color of the floor that needs to be paid attention to during floor acceptance should be kept uniform. If the color of the floor is uneven and there are obvious aesthetic issues, it does not meet the acceptance standards.
The above is the relevant content about the acceptance inspection after floor decoration. I believe you now have a certain understanding, and I hope it can help you.
