Manufacturing process of solid wood furniture – “spraying”
Guide: The primer shall be applied on the head. Before spraying, the dust shall be blown and wiped clean to check whether the wiping effect is good. The concentration of head primer is 16 seconds, and the spraying thickness is one cross.
- Wipe the color. After the color remover is prepared by professional technicians, it is necessary to try to wipe it first to confirm whether the color remover is correct and appropriate (subject to the color palette, and properly adjusted). Before wiping, the color remover shall be stirred evenly until there is no sediment. The brush used must be cleaned first, and the cloth to be wiped must be non fading cloth. Evenly brush the product with a brush without white leakage, and then quickly wipe the color remover with a cloth strip. Check whether the product has residual color remover that is not cleaned, whether there is sagging, uneven coloring, etc. 2. Bottom coloring: select the bottom color according to the requirements of the color plate, and adjust the color difference between materials through the bottom color. 3. Before spraying the head primer, the dust shall be blown clean to check whether the wiping effect is good. The concentration of head primer is 16 seconds, and the spraying thickness is one cross. 4. Dry and wait for 6-8 hours after spraying. 5. Sand removal: fill up all scratches first, and then sand gently with 320 # sandpaper, mainly to remove burrs on the painted products. 6. For the second primer, the dust shall be blown clean before spraying. The concentration of the primer is 18 seconds and the thickness is a cross. 7. Sand removal: fill the defective parts in place first, and then polish the paint surface smooth and flat with 320 # sandpaper. The paint surface shall not have large highlights. 8. Color repair. Before color repair, check whether the product is a good product, and clean up the dust and pollutants on the product. The technician shall prepare the color, then prepare a pre production sample according to the color plate, and the on-site supervisor shall determine the color before operation. 9. After oil sand and color repair, the product shall be dried for 4-6 hours, and then the surface of the product shall be polished with 800 # sandpaper. Attention shall be paid to the polishing process to prevent leakage, paint scratching and other phenomena. 10. Before finishing coat, it is necessary to check whether the product is a good product, whether the product surface is smooth, and the dust and attachments on the surface must be cleaned. The thickness of finish coat is 11-12 seconds, and the thickness is a cross. 11. Dry for 4 hours.
