Common edge banding materials include PVC, ABS, acrylic, melamine, solid wood and aluminum alloy.
PVC edge banding At present, PVC plastic edge banding is widely used for panel furniture edge banding in China, but its quality is extremely unstable. After trimming, the color difference is very obvious, and it is also easy to age and break. PVC wood grain edge banding is cured after printing on PVC substrate with ink and then roller coating with UV paint. The good simulation effect of PVC wood grain edge banding depends on the quality of printing ink. If high-quality ink is used to print the edge banding, the simulation effect of the edge banding is close to that of the board, the printing layer is rich, and the color fading in the room is not obvious within three years. At present, the edge banding with rich printing layers is mainly three color printing, followed by two color printing and one color printing. ABS resin edge banding ABS resin is one of the most advanced materials in the world at present. The edge banding strip made of ABS resin is not doped with calcium carbonate. After trimming, it looks bright and smooth, and will never appear white. However, the production cost of ABS resin is relatively high. In the market promotion, the price of ABS resin is about twice as high as that of PVC edge banding strip of the same specification. Professional and good writing, all in the door industry vision. Melamine edge banding, commonly known as paper edge banding, has the advantage of being easy to dry, difficult to stretch and deform in case of cold and heat. However, due to its brittleness and folding, it is easy to be damaged in furniture production and transportation. Solid wood veneer finger joint edge banding is mainly used on furniture with wood veneer. This kind of edge banding strip will stick non-woven fabric on the back to increase the strength of the veneer, prevent the veneer from cracking, and the finger joint length is 200m/roll, so it can be continuously used on the edge banding machine, improve the working efficiency, trim the edges neatly, and solve all the shortcomings of single veneer edge banding. The solid wood skin can be processed into an infinitely extended roll product of any specification with a thickness of 5 mm and a width of 5-300 mm. It has the characteristics of good edge banding effect, convenience and high utilization rate, and is suitable for mechanical edge banding of solid wood composite furniture and solid wood composite door components.
